Page 4 • JL Audio, Inc., 2016
Continued on Next Page
S T E P 8
Connect speaker cable to the terminal cup on
the Stealthbox®, and place the enclosure into
position between the Front and Rear Brackets.
Route the speaker cable as necessary.
S T E P 7
Align both Rear Brackets perpendicular to the
rail, as shown.
S T E P 6
Pull the carpet down from the side of the
vehicle. Slide a Rear Bracket over the Flange
Head Bolt, under the rail, as shown. Secure
with an M8 1.25 Hex Flange Lock Nut, and hand
tighten. Repeat for the second hole.
S T E P 5
Slide a 3/8 “ Flat Washer and a 3/8” Nylon
Washer over an M8 x 30 mm 1.25 Flange Head
Bolt (substitute an M8 x 45 mm 1.25 Flange
Head Bolt for vehicles with hard top), and
thread the assembly through one of the holes
indicated in the previous step. Repeat for the
second hole.
S T E P 4
Locate the two indicated holes at the top of
the side rail.
S T E P 3
Slide the Front Bracket over the factory stud,
followed by the seat belt bracket and nut, as
shown. Hand tighten.
S T E P 2
Fold the rear seat down, remove the nut at
the base of the seat belt bracket, and slide the
bracket off of the stud.
S T E P 1
Empty the cargo area of the vehicle.
SB-J-WRUD/10TW1 INSTR_SKU# 011387
