➔
➔
STEP 7: (A)
Thread the supplied socket cup
screw into the Stealthbox. Leave 1/2” exposed.
(B)
Place the Stealthbox into position and line
up the curved corners of the Stealthbox, that
are between the woofer and the square shape
of the Stealthbox.These corners need to line
up with the curvature of the transmission
hump floor as it goes to the rear and jets to
the right and left of the truck. Once into place,
push down with force.
(C)
With a 1/2” drill bit, drill at the impression that
was left by the Stealthbox in
STEP6
.
Cont.
From
Previous
Page
Continued on Next Page
➔
➔
STEALTHBOX WALL
THREADED INSERT
VEHICLE SHEET METAL
FENDER WASHER
SOCKET CUP SET SCREW
LOCK WASHER
FLAT WASHER
HEX NUT
STEP 8:
With the drilled out hole in the floor.
Expose the socket cup set screw 2” out of the
Stealthbox. Place the Stealthbox into position and
guide the socket cup set screw through the drilled
hole.
From under the vehicle, place the supplied fender
washer, flat washer, lock washer and hex nut onto
the socket cup screw.
STEP 9:
Place the jack back into the holder and
then place the jack assembly to the floor(same area
it was removed from) with the yellow knob facing
the passenger’s side rear door. With one factory
mounting bolt. Secure the assembly with to the dri-
ver’s side mounting threads. Use the second factory
mounting bolt to plug up the passenger’s side
mounting threads.
STEP10:
With a second person, place the rear
seat back into position. Wrap the shoulder belt in
front of the seat and through bottom crease of the
seat.
S B - G M - C L D RO / 1 0 W 3 v 3 , J L AU D I O, I n c 2 0 0 6
S h e e t S K U # 0 1 1 1 8 9 R ev i s i o n 3 / 8 / 2 0 0 6
Pa g e 2
w w w . j l a u d i o . c o m
*CAUTION*
Before drilling, make sure that you are not going to be
drilling into any gas lines, brake lines, transmission lines,
electrical wiring, transfer case(4x4 vehicles) or anything
else that might cause a reduction in your weekly pay.
Always wear eye protection when drilling.
With the use of a 1/2” drill bit and drill. Drill out the
floor at the impression on the wax square.
After the hole is drilled, remove the wax square
➔