JKEXER VIGOR 736, Руководство пользователя

Страница: 19 / 24

ADJUSTING THE RUNNING BELT TENSION
Adjust belt tension if it begins to slip on the rollers. This is important as it increases Longevity of the
treadmill's components. Follow below procedures until the running belt is not slipping. The tension
should be just tight enough not to slip.
1. Press the Master Power Switch (located at the front of the treadmill) to ON POSITION and ensure
safety key is properly placed onto the computer console. Press the START button to begin running
belt, then adjust the treadmill's speed To 3 mph.
2. Turn both adjustment screws an equal amount, approximately one-quarter turn Clockwise.
3. Slow the belt by holding onto the handrails and applying more weights as you Walk, (as if you were
walking downhill). When breaking heavily the belt may Slip.
4. If the belt slips, adjust one-quarter turn clockwise and repeat Step 3 as necessary.
ALWAYS BE CAREFUL NOT TO OVERTIGHTEN THE RUNNING BELT.
CLEANING AND INSPECTING THE RUNNING BELT
Turn off power and unplug from electrical outlet.
Carefully position the treadmill on its side.
Use a damp cloth to wipe off the inside of the running belt. Carefully rotate the running belt by hand to
clean the entire inside face. Return treadmill to its upright Position.
If running belt edges are frayed, check the running belt adjustment.
If seams are splitting, call your retailer or nearest authorized service center.
CLEANING
Before proceeding ensure that the treadmill's power is off and unplugged from the electrical outlet. To
remove dust use a small vacuum nozzle to carefully vacuum around all visible components.
To remove film or dirt use a slightly damp rag with a mild cleaning agent sprayed onto the rag only. Be
careful not to immerse any treadmill component with any liquids.
INSPECT FASTENERS AND IRING
Check
W
that all fasteners are properly tightened and all wiring is securely in place.
To avoid damaging fasteners, do not over tighten.
STORAGE
Store your treadmill in a clean and dry environment. Ensure the master power switch Is off and is
unplugged from the electrical wall outlet.
16