JK Exer FitLux 665, Руководство пользователя, Страница: 16 / 24

2. When starting HRC mode, actual heartbeat will be got within 30 seconds by 3 measurements.
First measurement will be done in 10 seconds after starting. If no heartbeat can be measured,
display for PULSE will be flashing for 3 times.
3. If actual heartbeat can ’ t be measured in 30 seconds, display for PULSE will be flashing for 3
times for the third time, machine will be stopped. Then "NO PULSE “ " will be flashing for 5 times,
and machine resumes to ready-to-operate mode, you may re-start the above procedure for
HRC mode or proceed with other exercise mode.
4. When actual heartbeat is 10 times more or10 times less than target heartbeat, measurement will
be done in every 5 seconds.
5. When actual heartbeat is or – 10 times compared with target heartbeat, measurement
will be done in every 10 seconds.
6. If Actual Heartbeat is HIGHER than Target Heartbeat, incline will be decreased 1% in every
measurement. When incline reaches to the lowest of 0%, but actual heartbeat is still more than
target heartbeat, speed will start decreasing at 0.2kph /0.1mph per measurement. If speed
and incline keep in lowest but actual heartbeat is 20 times more than target heartbeat for
continuous 20 seconds, machine will be automatically stopped. Then "NO PULSE" appears on
the screen and machine resumes to ready-to-operate mode.
7. If Actual Heartbeat is LOWER than Target Heartbeat, incline will be increased 1% in every
measurement. When incline reaches to the highest of 15%, but actual heartbeat is still lower
than target heartbeat, speed will start increasing at 0.2 kph/0.1mph per measurement. If speed
and incline keep in highest but actual heartbeat is still lower than target heartbeat, machine
will keep running as it is.
8. After preset time reaches to 0, machine will be stopped, and "HRC END" will be flashing for 5
times then the machine resumes to ready-to-operate mode.
9. The first time to press STOP button after starting, program will temporarily stop. When pressing
STOP button on second time, all figures on program will be reset.
OPERATION IN USER MODE U1 ~ U3
Step 1.
Press EDIT USER button to choose U1 – U3.
STEP 2
Press ENTER button, S-1 appears on the LCD, 1st section on incline/speed dot matrix flashes,
0% and 1.0 appear on Incline and Speed window.
Step 3.
Press SPEED / or INCLINE / to set desired speed & incline of S-1 (1st section). Then press
ENTER button to jump to S-2 (2nd section)
Step 4.
Repeat Step 3 to set all 16 sections from S-1 to S-16.
Step 5.
Press START button to begin operating followed by standard preset time 48 minutes.
Or follow next step.
14
▲
▼