Jinko JK2830, Руководство по эксплуатации

Страница: 46 / 71

JK2830 Series Operation Manual Chapter 3 Introduction to [DISP]
40
◼
Sweep mode ( SWEEP MODE )
◼
Sweep parameter setup (frequency [Hz] , level [V] , level [I] , bias [V] , bias
[I] )
◼
Sweep test point setup (sweep point)
◼
Selection of limit parameter ( LMT )
◼
High/low limit ( HIGH , LOW )
3.7.1 MODE and FAIL MODE
Mode and Fail mode menu is the same as the mode on <List sweep display>
page.
3.7.2 Test parameter
Sweep parameters can be: frequency [Hz], level [V] , level [I] , bias [V] , bias
[I] .
Operation steps for setting test parameter
1) Move the cursor the table to perform the setup of each sweep parameter:
LEV[V] and BIAS[x] ; the following soft keys will be displayed.
◼
LEVEL [V]
◼
LEVEL [A]
◼
BIAS [V]
◼
BIAS [A]
2) Press one of above soft keys to select the list sweep parameter.
3.7.3 Sweep parameter setup
Move the cursor to the table to perform the setup of each sweep parameter:
FREQ (HZ) , LMT , HIGH and LOW . Use numeric keys on the front panel to input
the data of test frequency/level/bias and high/low limit used to compare, as well
as the selected primary/secondary use to compare. After setting, if some inputs
are unnecessary, you can execute the function of “ OFF ” in the soft key zone to
delete the corresponding value.
In the bottom of the
LMT zone, parameter A indicates that the primary
parameters of the measurement result are use to compare with the high and low
limits of the table. Parameter B indicates that the secondary parameters of the
measurement result are used to compare with the high and low limits of the table.
“ --- “ means no compa re.