42
Press [Enter] to make settings for the following sub-items:
USB Configuration
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI
ownership change should be claimed by XHCI driver.
The optional settings are: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB Mass Storage Driver Support.
The optional settings are: [Disabled]; [Enabled].
USB Hardware Delays and Time-outs
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
The optional settings are: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
The optional settings are: [Auto]; [Manual].
Select
[Manual]
you can set value for the following sub-item: ‘
Device power-up
delay in seconds
’
,
the delay range in from 1 to 40 seconds, in one second
increments.
Network Stack Configuration
Press [Enter] to go to ‘
Network Stack
’ screen to make further settings.
Network Stack
Use this item to enable or disable UEFI Network Stack.
The optional settings are: [Disabled]; [Enabled].
When set as
[Enabled]
, the following sub-items shall appear:
Содержание LI1BV Series
Страница 19: ...14 M2B_PWR1 3 pin M 2 B key Power Select 2 0 pitch M2E_PWR1 3 pin M 2 E key Power Select 2 0 pitch...
Страница 23: ...18 4 SATAPWR1 4 pin SATA HDD Power Out Connector Pin 1 5V GND 12V GND 5 USB3 4 pin USB 2 0 Connector...
Страница 26: ...21 2 FP_AUDIO1 9 pin Line Out MIC In Header 2 0 pitch 3 FP_USB1 9 pin USB 2 0 Port Header 2 0 pitch...
Страница 30: ...25 10 TX RXCOM2 4 pin COM2 Header RS422 RS485 2 0 pitch 11 INVERTER1 6 pin LVDS Inverter Connector 2 0 pitch...