15
4. Install the screw back to the original spot.
*Note:
the screw post and nut fixed at location MH2 by default for 5.2cm M.2 B-key type-3052 card
installation. If you wish to install M.2 B-key type-3042 card, please remove the M.2 E-key type-2230
card and screw on the location MH1 before installing 4.2cm card to the slot. The other steps are the
same as M.2 B-key type-3052 card installation. (If you use M.2 B-key type-3042 card, M.2 E-key
type-2230 is not available; vice versa).
Notice: When all necessary installations are finished, please make sure that all cables
unplugged before installations are connected to their original locations before restoring the
back cover to the chassis and screws on the front panel/back panel/top cover locked to its
original locations (Refer to Part I). See to it that the cables inside are not blocked or pressed.
VI. To Install Hard Disk
1.
Place compatible SATA HDD upon HDD tray as showed above. Plug this side of the cable to
SATA power-in connector and SATA connector of the hard disk.
Содержание FDF10
Страница 2: ...2 I O Outlets...