Servomotor series JHN, JHQ, and JL – User Manual
Installation and commissioning
Jetter AG
214
Motors JHQ12, JHQ22 or JHQ24 (electrical connection SA-X or SB-X)
8.5.4
The following table shows the pinout of the Y-Tec power connector with M17 quick release:
Front view
Pin
Signal
Orange, 9-pole,
pins
Connector
Y-Tec
A
Phase 1
B
Phase 2
C
Phase 3
PE conductor
1
Brake+
2
Brake-
Housing
Outer shield is connected to connector housing.
The following table shows the pinout of the Y-Tec encoder connector with M17 quick release:
Front view
Pin
Resolver signal
HIPERFACE® signal
Green, 12-pole,
pins
Connector
Y-Tec
1
S1 ()
-
2
S3 (cosine-)
-
3
S4 (sine-)
Sine+
4
S2 (sine+)
Sine-
5
R1R (exciter )
6
R2L (exciter winding-)
Cosine-
7
Th1 (PTC)
Data- (RS-485)
8
Th2 (PTC)
Data+ (RS-485)
9
-
0 V
10
-
Power supply (7 … 12 V)
11
-
Thermal
12
-
Thermal sensor-
Housing Outer shield is connected to
connector housing.
Outer shield is connected
to connector housing.
Comment on the HIPERFACE
®
encoder:
On the JM-2xx, pins 12 and 9 in the encoder connector must be jumpered. A 9-pin Sub-D
connector must be fitted at the other end of the cable.
Suitable cables for these connectors can also be found in the Industrial Automation Catalog,
Products and Services.
