Jetter JC-120MC, Руководство пользователя

Страница: 75 / 634

Jetter AG 75
JC-120MC Mechanical and electrical installation
The configuration memory
The controller reads the parameters for initializing the IP interface out of the
configuration memory during the boot process. The user can access the data
stored in the configuration memory in the following ways:

A file located in the system directory of the file system lets you read out
and modifiy data.
 Various registers or one registers let you read out data.
The controller reads out data located in the configuration memory only during
the boot process. If you make changes to the configuration memory, reboot
the controller for these changes to take effect. Only this way these changes
take effect.
Before the controller further processes data from the configuration memory, it
checks them for plausibility. If entries are invalid or absent, the controller uses
the following default values:
Parameter Default value
IP address of the controller 192.168.10.15
Subnet mask 255.255.255.0
IP address of default gateway 0.0.0.0
IP address of DNS server 0.0.0.0
Controller name JetControl120MC
Suffix type of the name 0
IP port number for debugger 52000
IP port number for JetIP 50000
Name for AutoCopy command file /SD/autocopy.ini
The configuration memory is located on the backplane module.
Owing to this approach, configuration data will be preserved when the function
module is replaced.
 The configuration file (see page 76)

Configuration registers (see page 80)
Introduction
Enabling conditions
Default values
Storage
location/controller
replacement
Related topics