NOTES:
•
Ensure that all the M12 hardware is installed with the nuts on top of the
connecting arms as shown in the figure.
•
The fan blades should be installed alternatively to balance the load on the
guy cables. It is recommended not to fully tighten the hardware until all
fan blades and blade retainers have been installed on the connecting arms.
5.3 Install all the 5 fan blades onto the connecting arms and fully tighten all
the pretensioned hardware.
6.
Installing the Bottom Cover
6.1 Install the fan cover on the motor using the supplied M4 X 8mm screw.
Electrical Information
IMPORTANT NOTES
•
It is the responsibility of the installer to ensure all electrical standards of the
install cable used is in accordance with all local and regional electrical
regulations.
•
Refer Safety Instruction on page 3 before proceeding.
•
Exercise caution and common sense when powering the fan.
•
Do not connect the fan to a damaged or hazardous power source.
•
Do not attempt to resolve electrical malfunctions or failures on your own.
Black (no
longer silver)
metal ring
