Jet JWL-1840DVR, Инструкция по эксплуатации и каталог запасных частей

Страница: 7 / 44

7
5.0 Setup and assembly
The Lathe must be
disconnected from power during assembly.
5.1 Shipping contents
Carton contents (see Figure 5-1)
1 Lathe bed with headstock, tool support and
tailstock – A
1 Tool rest – B
2 Legs – C
1 Spur center – D
1 Live single bearing center – E
1 Live cone center – F
1 Live cone center pin – G
1 Knockout rod – H
1 Faceplate – J (installed on lathe)
1 Tool rest extension – K
1 Faceplate wrench – L
4 Adjustable foot – M
1 Tool shelf – N
2 Riser blocks – P
1 Hardware package
1 Operating Instructions & Parts Manual
1 Product registration card
Hardware package (p/n JWL1840-HP) contents:
8 Soc. hd. cap screws, 5/16x1-1/4 – HP001
8 Lock washers, 5/16 – HP002
8 Flat washers, 5/16 – HP003
2 Soc. hd. cap screws, 3/8x3/4 – HP004
6 Lock washers, 3/8 – HP005
4 Hex cap screws, 3/8x1-1/4 – HP006
4 Flat washers, 3/8 – HP007
5.2 Tools required for assembly
Hex keys, 6mm, 8mm
Open end wrench, 14mm
5.3 Unpacking and cleanup
1. Remove all smaller items from main carton. Do
not discard carton or packing material until
lathe is assembled and running satisfactorily.
2. Inspect contents for shipping damage; if any is
found, report it to your distributor.
3. Compare contents of shipping carton with the
contents list in this manual. Report shortages,
if any, to your distributor.
Note: Check lathe
first – some parts may have been pre-installed.
4. Exposed metal areas of the Lathe, such as
bedways and spindles, have been factory
coated with a protectant. This should be
removed with a soft cloth and a cleaner-
degreaser. Clean the bed areas under
headstock, tailstock and tool support base. Do
not use an abrasive pad, and do not allow
solvents to contact painted or plastic areas.
Figure 5-1: shipping contents (not to scale)
5.4 Installing leg set and riser blocks
See Figures 5-2 and 5-3.
1. If you desire to install the riser blocks for a 4”
height increase, mount them to bottom of legs
using fasteners (HP006/5/7) Tighten firmly.
2. Install adjustable feet into bottom of legs or
riser blocks (Figure 5-2) and tighten hex nut
against leg casting. The feet can be adjusted
later.
Figure 5-2: riser blocks and feet
Lathe is heavy – use caution
during leg installment procedures. Use straps
in good condition. Straps/lifting mechanisms
must be properly rated for lathe weight.