10
Canister Kit Assembly
If you purchased Model DC-650CK Dust Collector, this
section describes the assembly and installation of the
contents of the Canister Kit (SN 708737C).
Canister Filter Installation
Referring to Figure 7:
1. Place the canister filter so that it fits snugly over
the housing and tighten the four
knobs
(A).
2. Mount
handle
(B) to the
arm
(C) with an M8
flat
washer
(D), M8
lock washer
(E) and M8
hex nut
(F).
3. Thread an M10
hex nut
(G) onto the threaded rod
found on top of the canister filter followed by an
M10
lock washer
(H), and M10
flat washer
(I).
4. Mount
the
arm
(C) to the threaded rod on top of
canister with one M10
flat washer
(J), and M10
hex nut
(K).
Collector Bag Installation
1. Place the
snap ring
(K, Fig. 8) over the top of
plastic bag
(L, Fig. 8) and fold over the bag
approximately three inches.
2. Insert the snap ring of the collector bag into the
bottom of the housing at an angle, see Figure 9.
3. Pull down on the ring to make sure it “seats” in the
housing.
Note:
Make sure the snap ring “snaps” into place
in the housing, and also that the plastic bag hangs
down approximately 3” so that there are no air
leaks.
Figure 7
Figure 8
Figure 9
