Jet DC-1200VX Series, Оригинальное руководство пользователя

Страница: 9 / 24

9
Base Unit Assembly
Base
1. Install four casters to the under side of the base as
pictured in Fig. 2.
Referring to Figure 1:
2. Thread the hex nut (B) onto the caster shaft. Then
slide the lock washer (A) over the caster shaft.
Thread the caster shaft into the threaded hole on the
underside of the base, turn until snug. Tighten the
nut (B) against the base with a 14mm wrench. This
will give the caster proper clearance.
Motor and Fan Assembly
Referring to Figure 2:
3. Place the base (C) with casters on the ground.
Attach the motor and fan assembly (A) to the base
using four each M8 x 16 hex cap screws, and M8 flat
washers (B). Tighten with a 13mm wrench.
The dust collector must not be
connected to the power source during assembly.
Failure to comply may result in serious injury!
Referring to Figure 3:
4. Attach impeller cover (A) to fan housing (D) using
eight M6 x 12 pan head screws (B). Press the inlet
ports (C) onto the inlet guard until it snaps into place.
To reduce the risk of injury from
moving parts, always keep inlet port covered with the
caps provided, if they are not connected to a hose.
Failure to comply may result in serious injury!
Connector Housing
5. Attach three support legs (A, Fig. 4) to the base
using six M8 x 16 hex cap bolts and six M8 flat
washers (B, Fig. 4). Hand-tighten only at this time.
Figure 1
Figure 2
Figure 3
Figure 4