3
Wiring
WARNING! Only connect the unit to a 12-volt power supply with proper grounding.
Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the bat-
tery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch.
NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the radio. The
VM9214
R
uses one 15 amp fuse, located in the black filter box in-line with the main wire harness.
Final Installation
After completing the wiring connections, turn the unit on to confirm operation (ignition switch must be on). If
unit does not operate, recheck all wiring until problem is corrected. Once proper operation is achieved, turn off
the ignition switch and proceed with final mounting of the chassis.
Connect wiring adapter to existing wiring harness.
Connect antenna lead.
Carefully slide the radio into the mounting sleeve, making
sure it is right-side-up, and secure with the original 4 screws.
Attach one end of the perforated support strap (supplied) to
the screw stud, which is screwed into the threaded insert on
the back of the unit, using the hex nut provided. Fasten the
other end of the perforated strap to a secure part of the
dashboard either above or below the radio using the screw
and hex nut provided. Bend the strap to position it as
necessary.
Replace any items you removed from the dashboard.
ISO-DIN Installation
Remove mounting sleeve brackets.
Remove trim ring.
Mount factory brackets on new radio using existing screws
from old radio.
Slide radio chassis into dash opening and secure.
Re-install dash panel.
EJECT
A / V
INPUT
EJECT
A / V
INPUT
1
2
3
4
5
1
2
3
4
5
CAUTION! The rear of the radio must be
supported with the strap to prevent dam-
age to the dashboard from the weight of
the radio or improper operation due to
vibration.
NOTE: For proper operation of the CD/
DVD player, the chassis must be mounted
within 20° of horizontal. Make sure the unit
is mounted within this limitation.
Remove Mounting
Sleeve Brackets
EJECT
A / V
INPUT
Содержание VM9214R
Страница 14: ...14 NAV102 BTM10 Bluetooth VM9214R a b c EJEC T A V INPUT 1 2 3...
Страница 15: ...15 12 VM9214R 15 1 2 4 5 3 ISO DIN 1 2 4 5 3 EJECT A V INPUT EJEC T A V INPUT DVD 20 EJEC T A V INPU T...
Страница 18: ...18 NAV102 BTM10 Bluetooth VM9214R a b c EJEC T A V INPUT 1 2 3...
Страница 19: ...19 12 VM9214R 15 1 2 3 4 5 1 2 3 4 5 ISO DIN DVD 20 EJEC T A V INPU T EJECT A V INPUT EJEC T A V INPUT...