Jensen JWM30, Инструкция по установке и эксплуатации, Страница: 9 / 16

TUNER OPERATION
JWM
30
9
Select a Band
Manual Tuning
Auto Seek Tuning
Preset Stations
Press BAND button (18) repeatedly to change between two AM bands
(AM1, AM2) and three FM bands (FM1, FM2 and FM3).
Press the or buttons (9, 7) to seek stations up/down step by step.
Press and hold the or buttons (9, 7) to automatically seek the next or
previous strong station.
Six numbered preset buttons store and recall stations for each AM and FM band.
Store Preset Station
Select a band (if needed), then select a station. Press and hold a 1-6 preset
button for 2 seconds. The current station will be stored, and corresponding
preset number will appear on the display.
Recall Preset Station
Select a band (if needed), Press a preset button momentarily, and the unit will
tune to the corresponding stored station.
Automatically Store / Preset Scan (AS/PS)
Automatically Store
Select an AM or FM band. Press and hold the button (8) to access tuner menu list:
AUTO STORE & PRESET SCAN. Press button (8) repeatedly until “AUTO STR”
appears on the display. Press the
ENTER knob (22) to begin the Auto Store function
and the unit will automatically scan for and store 12 or 18 strongest station for all
bands. To stop this function before the automatic storing is complete, press the
Press or (9, 7).
NOTE: Only station detected with sufficient signal strength will be stored in the
preset channel automatically.
Preset Scan
Select an AM or FM band. Press and hold the button (8) to access tuner menu list:
AUTO STORE & PRESET SCAN. Press button (8) repeatedly until “PRE SCAN”
appears on the display. Press the
ENTER knob (22) to scan stations stored in the
current band, the unit will pause for 10 seconds at each preset station. Press the
Press or (9, 7) to stop scanning when the desired station is reach.
10
1
20
22
21
2 3 4 5 6 7 8 9
19 18 17 16 15 14 13 12
11
24
23