Jensen AVX1B4S Скачать руководство пользователя страница 1

128-7066

1 of 2

Transmitter Programming Guide

This transmitter is designed for use with your upgrade remote start
unit and is programmed by using the remote start's program switch in
combination with the transmitter button.  Although this transmitter can
be programmed into any of the Audiovox remote start and or alarm,
alarm remote start systems, it will offer limited use and should be
used for the remote start upgrade only.

To program this transmitter into your remote start upgrade unit:

1. Turn the ignition to the on position
2. Press and release the programming switch 3 times
3. Press and hold, for 3 seconds, the button of the transmitter you

wish to add until the parking light flashes indicating the
transmitter has been learned.

4. Repeat step 3 for each transmitter up to a total of 4.

Turn the ignition off to exit the program mode.

NOTE:  Do not allow more than 15 seconds to lapse between steps

or the program mode will be automatically exited and you will
have to start over.

The transmitter incorporates a small red LED visible through the case.
This LED can be  used to indicate battery condition. You will notice a
decrease in transmitter range as the battery condition deteriorates.
Transmitter battery replacement is recommended at least every 10 to 12
months, depending upon how frequently the transmitter is used.
 To replace the battery...

1.  Remove the transmitter cover by removing the small screw from

the back of the transmitter case.

2. Remove the discharged battery or batteries, making note of the

orientation of the + and -  contacts, and dispose of properly.

3.  Install the new (type CR1220) batteries, taking care to orient the

+ and - contacts properly.

4.  Replace the transmitter cover, taking care not to damage the LED

or switches on the circuit board.

Model  AVX1B4S

Отзывы: