Jenn-Air RISE JDS1450ML, Руководство пользователя

Страница: 13 / 56

13
Level Range
1. Place level on the oven bottom, as indicated in one of the two
figures below, depending on the size of the level. Check with
the level side to side and front to back.
2. If range is not level, use a wrench or pliers to adjust leveling
legs up or down until the range is level.
NOTE: Range must be level for satisfactory baking
performance and best cleaning results using AquaLift ® Self-
Clean Technology.
Electrical Connection - U.S.A. Only
If your home has a 4-wire direct connection, go to “Install Using
Direct Wire”.
Install Using Direct Wire
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper or 6 gauge aluminum wire.
Electrically ground range.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Direct Wire Strain Relief
1. Disconnect power.
2. Remove the lower access cover screws located on the back of
the range. Pull the bottom of the cover toward you and out to
remove cover from range.
A
B
C
A.
Mounting tabs (3)
B.
Lower access cover
C.
Screws (2)
3. Assemble a UL listed conduit connector in the opening.
A
B
A.
Removable retaining nut
B.
Conduit
4. Tighten strain relief screw against the flexible conduit.
Direct Wire Installation: Copper or Aluminum Wire
This range may be connected directly to the fuse disconnect or
circuit breaker box. Depending on your electrical supply, make the
required 4-wire connection.
1. Strip outer covering back 3" (7.6 cm) to expose wires. Strip
the insulation back 3/8" (1.0 cm) from the end of each wire.
2. Allow enough slack in the wire to easily attach the wiring
terminal block.
3. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
Electrical Connection Options
Electrical
Connection Options And you will be
connecting to: Go to Section:
4-wire direct A circuit breaker
box or fused
disconnect 4-Wire Connection:
Direct Wire
(7.6 cm)
3"
1.0 cm
3/8"
3/8"
(1.0 cm)
(12.7 cm)
5"