WWW.JEIUK.COM
This document is protected by copyrights.
Copying, using, or distributing without permission of Ansa Group Ltd is prohibited.
8
3.
STARTUP AND OPERATION
3.1.
Mounting and operating the annular cutter
Unplug the power cord from the power outlet and raise the motor by rotating the spoke
handles clockwise (
1
, Figure 3). Insert the proper pilot pin into the annular cutter (
2
), then
wear protective gloves and place the cutter into the arbor (
3
) in such a way to align the flats
4
with the set screws
5
. Finally, tighten both set screws with the supplied 4 mm hex wrench.
To dismount the cutter, proceed in reverse order.
Figure 3.
Mounting the annular cutter
All safety precautions must be closely observed.
1
2
3
5
4
