Jeep Wrangler 4xe 2021, Руководство пользователя

Страница: 16 / 88

14 GETTING TO KNOW YOUR VEHICLE
5. To stop the charging process, disconnect
the vehicle charge connector first and
then the EVSE from the wall receptacle.
To disengage the vehicle coupler, push the
button on the charge connector first and
then remove the connector from the vehicle
charge inlet.
Removing The Charge Connector From The Vehicle
Charge Inlet
6. Close the inlet door when an EVSE is not
connected to the vehicle.
NOTE:
It is good practice to keep the ignition in the OFF
position while conducting Level 1 charging. This
minimizes any additional vehicle loads the EVSE
has to support. The additional electrical loads will
extend the high voltage battery charging time.
Troubleshooting Using The Status
Indicator Display
If the vehicle is not charging properly, consult
the status indicator lights.
The Green LED signals correct operation of the
system.
The Red LED signals a failure in the charging
system.
The Yellow LED signals a failure with the outlet.
LED Indicator Lights
1 — Green LED
2 — Red LED
3 — Yellow LED
21_JL_H_SU_EN_USC_t.book Page 14