5. Repeat on the opposite side.
6. Utilizing two people, lift the soft top up and away
from the vehicle, careful to avoid the vehicle’s sport
bar, trim, and tire carrier. Store the soft top in a
safe, clean, and dry location.
7. Using the provided #50 Torx head driver and
ratchet, unscrew the Torx screw on both rear cor-
ners of the vehicle, removing the retainers.
INSTALLING THE SOFT TOP
1. If currently installed, remove the hard top
2. Install the door rails, starting with the front, followed
by the rear on each side. For instructions and appro-
priate torque specifications for the door rail Torx
screws
3. Install the rear retainers on each side of the rear of
the vehicle using the provided #50 Torx head driver
and ratchet. Refer to the following table for recom-
mended torque specifications.
CAUTION!
Do not overtighten Torx screws. Damage to the retain-
ers will occur.
Torque
Specification
For Torx Screw
Maximum
Minimum
119.5 in-lb
150.5 in-lb
106.2 in-lb
13.5 N·m
17.0 N·m
12.0 N·m
CAUTION!
Failure to follow the next steps could result in dam-
age to the Soft Top or vehicle.
Step Four
Step Six
Step Seven
Step Three
GETTING TO KNOW YOUR VEHICLE
97
2
5538906_24_JL_OM_EN_USC_t_E1.pdf 97
5/22/2023 9:02:20 AM