OUTSIDE MIRRORS WITH TURN
SIGNAL — IF EQUIPPED
Driver and passenger outside mirrors with turn signal
lighting contain LEDs, which are located in the upper
outer corner of each mirror.
The LEDs are turn signal indicators, which flash with
the corresponding turn signal lights in the front and
rear of the vehicle. Turning on the Hazard Warning
flashers will also activate these LEDs.
POWER MIRRORS — IF EQUIPPED
The power mirror controls are located on the door panel
next to the door handle.
The power mirror controls consist of mirror select but-
tons and a four-way mirror control switch. To adjust a
mirror, push either the L (left) or R (right) button to
select the mirror that you want to adjust.
Using the mirror control switch, push any of the four
arrows for the direction that you want the mirror to
move.
HEATED MIRRORS — IF EQUIPPED
These mirrors are heated to melt frost or ice.
This feature will be activated whenever you
turn on the rear window defroster
(if equipped)
UNIVERSAL GARAGE DOOR OPENER
(HomeLink®) — IF EQUIPPED
Use this QR code to access your digital
experience.
•
HomeLink® replaces up to three
hand-held transmitters that operate
devices such as garage door open-
ers, motorized gates, lighting, or
home security systems. The
HomeLink® unit is powered by your vehicle’s 12 Volt
battery.
•
The HomeLink® buttons that are located in the
overhead console or sun visor designate the three
different HomeLink® channels.
•
To operate HomeLink®, push and release any of the
programmed HomeLink® buttons. These buttons
will activate the devices they are programmed to
with each press of the corresponding HomeLink®
button.
•
The HomeLink® indicator light is located above the
center button.
NOTE:
HomeLink® is disabled when the Vehicle Security sys-
tem is active
BEFORE YOU BEGIN
PROGRAMMING HOMELINK®
For efficient programming and accurate transmission of
the Radio Frequency (RF) signal, it is recommended
that a new battery be placed in the hand-held transmit-
ter of the device that is being programmed to the
HomeLink® system. Make sure your hand-held trans-
mitter is programmed to activate the device you are
trying to program your HomeLink® button to.
Ensure that your vehicle is parked outside of the garage
before you begin programming.
It is recommended that you erase all the channels of
your HomeLink® before you use it for the first time.
Power Mirror Switch
HomeLink® Buttons On Sun Visor
Scan me
GETTING TO KNOW YOUR VEHICLE
67
2
5538906_24_JL_OM_EN_USC_t_E1.pdf 67
5/22/2023 9:02:19 AM