On vehicles equipped with a manual transmission, the
ACC system cannot be set when the vehicle speed is
below 20 mph (32 km/h) or when the vehicle is in
FIRST gear.
NOTE:
•
Keeping your foot on the accelerator pedal can
cause the vehicle to continue to accelerate beyond
the set speed. If this occurs, the message “DRIVER
OVERRIDE” will display in the instrument cluster
display.
•
If you continue to accelerate beyond the set speed
while ACC is enabled, the system will not be control-
ling the distance between your vehicle and the
vehicle ahead. The vehicle speed will only be deter-
mined by the position of the accelerator pedal.
To Cancel
The following conditions cancel the ACC or Fixed Speed
Cruise Control systems:
•
The brake pedal is applied
•
The CANC button is pushed
•
The Anti-Lock Brake System (ABS) activates
•
The gear selector is removed from the DRIVE
position
•
The Electronic Stability Control/Traction Control Sys-
tem (ESC/TCS) activates
•
The vehicle parking brake is applied
•
The braking temperature exceeds normal range
(overheated)
•
The Trailer Sway Control (TSC) activates
•
The vehicle speed is less than 15 mph (24 km/h)
(manual transmission only)
•
The clutch is pressed for more than 10 seconds
(manual transmission only)
•
The vehicle is placed in NEUTRAL for more than
10 seconds (manual transmission only)
•
The driver shifts to FIRST gear (manual transmission
only)
The following conditions will only cancel the ACC
system:
•
Driver seat belt is unbuckled at low speeds
•
Driver door is opened at low speeds
To Turn Off
The system will turn off and erase the set speed in
memory if:
•
The Adaptive Cruise Control (ACC) on/off button is
pushed
•
The Fixed Speed Cruise Control on/off button is
pushed
•
The ignition is placed in the OFF position
•
4WD Low is engaged
To Resume
If there is a set speed in the memory, push the RES
button and then remove your foot from the accelerator
pedal. The instrument cluster display will show the last
set speed.
Resume can be used at any speed above 20 mph
(32 km/h) when only Fixed Speed Cruise Control is
being used.
Resume can be used at any speed above 0 mph
(0 km/h) when ACC is active.
NOTE:
•
While in ACC mode, when the vehicle comes to a
complete stop longer than two seconds, the system
will cancel. The driver will have to apply the brakes
to keep the vehicle at a standstill.
•
ACC cannot be resumed if there is a stationary
vehicle in front of your vehicle in close proximity.
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed
that is too high or too low for prevailing traffic and
road conditions could cause the vehicle to accelerate
or decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.
To Vary The Speed Setting
To Increase Or Decrease The Set Speed
After setting a speed, you can increase the set speed by
pushing the SET
(+)
button, or decrease speed by push-
ing the SET
(-)
button.
U.S. Speed (mph)
•
Pushing the SET
(+)
, or SET
(-)
button once will
result in a 1 mph speed adjustment. Each subse-
quent tap of the button results in an adjustment of
1 mph.
•
If the button is continually pushed, the set speed
will continue to adjust in 5 mph increments until the
button is released. The new set speed is reflected in
the instrument cluster display.
STARTING AND OPERATING
175
4
5538906_24_JL_OM_EN_USC_t_E1.pdf 175
5/22/2023 9:02:24 AM
