Screen Setup Driver Selectable Items
Upper Left and Right
None
Current MPG
(or L/100km,
km/L)
Average MPG
(or L/100km,
km/L)
Outside Temp
Compass
Trip A Distance
Range To Empty
Time
Trip B Distance
Center
None
Compass
Time
Outside Temp
Average MPG
(or L/100km,
km/L)
Trip A Distance
Range to Empty
Audio
Speedometer
Current MPG
(or L/100km,
km/L)
Trip B Distance
Menu Title
Favorite Menus
Speedometer
Stop/Start
Vehicle Info
Off Road –
If Equipped
(show/hide)
Messages
Driver Assist –
If Equipped
(show/hide)
Fuel Economy
(show/hide)
Screen Setup
Trip Info
(Show/Hide)
Audio
(show/hide)
Gear Display — If Equipped
•
Full
•
Single
Current Gear — If Equipped
•
On
•
Off
Odometer — If Equipped
•
Show
•
Hide
Defaults (Restores All Settings To Default Settings)
•
Cancel
•
Restore
The menu with (show/hide) means user can press
OK
button to choose show or hide this menu on the instru-
ment cluster display.
Phone Call Status — If Equipped
A pop-up message for an incoming call will appear on
any screen within your instrument cluster. The pop-up
message will appear on your screen until it is cleared
out of the call is ignored, answered, or the calling ends.
NOTE:
The Uconnect Settings can be programmed to turn the
pop-up off. This will not affect the audio menu or any
phone status information
Any incoming calls, active calls, and outgoing calls will
take the place of your audio information.
A caller’s name will only be displayed if:
•
A number is associated with the call. The phone num-
ber will be displayed in place of the caller’s name.
•
The test/font of the name is not supported by the
instrument cluster. The instrument cluster will not
display anything in place of the name.
•
The caller’s name exceeds the maximum number of
characters. The last two to three digits that will fit
will be replaced with “...”.
NOTE:
Any audio information will return to the instrument clus-
ter once the call has ended.
BATTERY SAVER ON/BATTERY
SAVER MODE MESSAGE —
ELECTRICAL LOAD REDUCTION
ACTIONS — IF EQUIPPED
This vehicle is equipped with an Intelligent Battery Sen-
sor (IBS) to perform additional monitoring of the electri-
cal system and status of the vehicle battery.
In cases when the IBS detects charging system failure,
or the vehicle battery conditions are deteriorating, elec-
trical load reduction actions will take place to extend
the driving time and distance of the vehicle. This is
done by reducing power to or turning off non-essential
electrical loads.
Load reduction is only active when the engine is run-
ning. It will display a message if there is a risk of battery
depletion to the point where the vehicle may stall due
to lack of electrical supply, or will not restart after the
current drive cycle.
When load reduction is activated, the message “Battery
Saver On” or “Battery Saver Mode” will appear in the
instrument cluster display.
These messages indicate the vehicle battery has a low
state of charge and continues to lose electrical charge
at a rate that the charging system cannot sustain.
132
GETTING TO KNOW YOUR INSTRUMENT PANEL
5538906_24_JL_OM_EN_USC_t_E1.pdf 132
5/22/2023 9:02:21 AM
