Jeep RENEGADE 2017, Руководство пользователя

Страница: 155 / 332

NOTE:
Even if the transmission can be reset, we
recommend that you visit your authorized
dealer at your earliest possible convenience.
Your authorized dealer has diagnostic equip-
ment to determine if the problem could recur.
If the transmission cannot be reset, autho-
rized dealer service is required.
Ignition Park Interlock
Vehicles Equipped With Keyless Enter-N-Go:
This vehicle is equipped with an Ignition Park
Interlock, which requires the transmission to
be in PARK before the ignition can be turned
to the OFF mode. Also, the transmission is
locked in PARK whenever the ignition is in
the OFF mode.
Brake/Transmission Shift Interlock
System
This vehicle is equipped with a Brake Trans-
mission Shift Interlock system (BTSI) that
holds the transmission gear selector in PARK
unless the brakes are applied. To shift the
transmission out of PARK, the ignition must
be in the RUN mode (engine running or not)
and the brake pedal must be pressed.
The brake pedal must also be pressed before
pushing the button on the gear selector to
shift from NEUTRAL into DRIVE or REVERSE
when the vehicle is stopped or moving at low
speeds.
SPEED CONTROL
When engaged, the Speed Control takes over
accelerator operations at speeds greater than
25 mph (40 km/h).
The Speed Control buttons are located on the
right side of the steering wheel.
Speed Control Buttons
1 — SET+/Accel
2 — RES/Resume
3 — On/Off
4 — SET-/Decel
5 — CANC/Cancel
153