274
STARTING AND OPERATING
Off-Road Driving Tips
NOTE:
Prior to off-road driving with non-Summit
models that are also equipped with an Off Road
Package, remove the lower fascia to prevent
damage. The lower fascia is attached to the
lower part of the front fascia with seven quarter
turn fasteners and can be removed by hand.
The front license plate bracket must be
removed first if equipped.
Front Air Dam
NOTE:
On Summit models the lower front fascia is not
removable.
Lower Front Fascia Removal:
1. Remove the seven quarter turn fasteners.
2. Starting on one side of the vehicle,
disengage lower fascia from the upper
fascia. Grasp the portion inside the wheel
well. Pulling it downwards and toward you,
separate the tabs from the slots in the
upper fascia.
3. Continue working your way across the
vehicle, separating the remaining tabs from
the slots in the upper fascia.
NOTE:
Do not allow the lower fascia to freely hang from
the tabs in the opposite corner as damage to
lower and upper fascia may result.
4. Store the lower fascia in a safe location.
NOTE:
It is recommend to also remove the radar
sensor on vehicle equipped to Adaptive Cruise
Control (ACC). This radar sensor is specifically
calibrated to your vehicle and is not inter
-
changeable with other radar sensors.
Radar Sensor Removal Procedure (If Equipped
With Adaptive Cruise Control [ACC]):
1. With the lower fascia removed, which
provides access to the sensor and bracket,
disconnect the wiring harness from the
sensor.
2. Using a suitable tool, disconnect the wire
clip from the bracket.
NOTE:
Before the next step, it is recommended to
scribe location to assist in reinstallation.
3. Using a suitable tool, remove the two
fasteners that hold the sensor bracket to
the bumper beam.
1 — Front Bumper
2 — Front Air Dam Fasteners
20_WK_OM_EN_USC_t.book Page 274