Jeep GLADIATOR 2023, Руководство пользователя

Страница: 34 / 420

32 GETTING TO KNOW YOUR VEHICLE
5. Insert the hinge shoulder bolt through the bottom of
the upper door hinge up into the mirror bracket, then
rotate the bracket knob toward the rear of the vehicle
to secure the mirror bracket to the A-pillar.
Attaching Mirror Bracket To The Vehicle
6. Tighten both the bracket bolt and the hinge shoulder
bolt with a #40 Torx head driver. Recommended
torque specification for the bracket bolt is 6 ft-lb
(8 N·m), and 7.5 ft-lb (10 N·m) for the hinge
shoulder bolt.
7. Lower the mirror assembly onto the mirror bracket.
Lower Mirror Assembly Onto Bracket
8. Insert the three mirror screws into the mirror
assembly, and tighten into the mirror bracket using a
#30 Torx head driver. Recommended torque specifi -
cation for the mirror screws is 4 ft-lb (5.5 N·m).
Mirror Screw Locations
9. Repeat the steps on the other side of the vehicle.
NOTE:
If this kit is being installed with the optional lamp bracket,
the bracket bushing from step 4 is not needed. Use the
spacer from the lamp bracket.
H
ALF
-D
OORS
— I
F
E
QUIPPED
1 — Bracket Knob
2 — Hinge Shoulder Bolt
CAUTION!

Do not run half-doors through an automatic car
wash. This may result in scratches and wax buildup
on the windows.

Careless handling and storage of the half-doors may
damage the seals resulting in water leaks into the
interior of the vehicle.

The upper half-doors must be positioned properly to
ensure sealing. Improper installation can cause
water leaks into the interior of the vehicle.

Store the zipper pulls of the upper half-door windows
at the upper B-pillar area for both front and rear
doors to avoid damage to the windows when
not in use.

Do not attempt to operate the half-door zipper in
temperatures of 41°F (5°C) or below. Damage to the
window may occur.
23_JT_OM_EN_USC_t.book Page 32