Jeep GLADIATOR 2023, Руководство пользователя

Страница: 18 / 420

16 GETTING TO KNOW YOUR VEHICLE
(Continued)
2. Remove the depleted battery by inserting a small
flat-blade screwdriver into the battery removal slot
and sliding the battery forward and upward being
careful not to damage the electronic board
underneath.
Battery Replacement
3. Install the new battery into the key fob, making sure
the positive (+) side is facing up. Slide the battery
until it is seated securely below the tabs.
4. Reassemble the back cover making sure it is properly
aligned before snapping it back in place.
Programming And Requesting Additional
Key Fobs
Programming the key fob may be performed by an
authorized dealer.
NOTE:
 Once a key fob is programmed to a vehicle, it cannot be
repurposed and reprogrammed to another vehicle.
 Only key fobs that are programmed to the vehicle
electronics can be used to start and operate the
vehicle. Once a key fob is programmed to a vehicle, it
cannot be programmed to any other vehicle.
Duplication of key fobs may be performed at an authorized
dealer. This procedure consists of programming a blank
key fob to the vehicle electronics. A blank key fob is one
that has never been programmed.
NOTE:

When having the Sentry Key Immobilizer system
serviced, bring all vehicle keys with you to an autho -
rized dealer.

Keys must be ordered to the correct key cut to match
the vehicle locks.
SENTRY KEY
The Sentry Key Immobilizer system prevents unauthorized
vehicle operation by disabling the engine. The system
does not need to be armed or activated. Operation is
automatic, regardless of whether the vehicle is locked or
unlocked.
The system uses a key fob, keyless push button ignition
and a Radio Frequency (RF) receiver to prevent
unauthorized vehicle operation. Therefore, only key fobs
that are programmed to the vehicle can be used to start
and operate the vehicle. The system cannot reprogram a
key fob obtained from another vehicle.
After placing the ignition switch in the ON/RUN position, the
Vehicle Security Light will turn on for three seconds for a bulb
check. If the light remains on after the bulb check, it indicates
that there is a problem with the electronics. In addition, if the
light begins to flash after the bulb check, it indicates that
someone attempted to start the engine with an invalid key
fob. In the event that a valid key fob is used to start the engine
but there is an issue with the vehicle electronics, the engine
will start and shut off after two seconds.
WARNING!

The integrated key fob contains a coin cell battery.
Do not ingest the battery; there is a chemical burn
hazard. If the coin cell battery is swallowed, it can
cause severe internal burns in just two hours and
can lead to death.

If you think a battery may have been swallowed or
placed inside any part of the body, seek immediate
medical attention.

Keep new and used batteries away from children.
If the battery compartment does not close securely,
stop using the product and keep it away from children.
WARNING!
 Always remove the key fobs from the vehicle and lock
all doors when leaving the vehicle unattended.

Always remember to place the Keyless Enter ‘n Go™
Ignition in the OFF position when exiting the vehicle.
WARNING!
23_JT_OM_EN_USC_t.book Page 16