Jeep GLADIATOR 2023, Руководство пользователя

Страница: 178 / 420

176 STARTING AND OPERATING
TRAILCAM SYSTEM — IF EQUIPPED
Your vehicle may be equipped with a TrailCam that allows
you to you see an on-screen image of the front view of your
vehicle. The image will be displayed on the touchscreen
display along with a caution note “Check Entire
Surroundings” across the top of the screen.
Front View Camera
NOTE:
The system will stay active while in 4WD Low.
The TrailCam system has programmable settings that may
be selected through the Uconnect system
Ú
page 199.
Manual Activation Of The TrailCam
TrailCam view can be activated via the below methods:

Press the FWD Camera button on the controls screen.
 Press the Forward Facing Camera button on the apps
menu.
 Press the TrailCam button on the Off Road Pages.

Press the Off Road+ button when Auto Launch
Off Road+ (if equipped) has been selected under
camera settings.
The TrailCam view can also be activated by pressing the
icon on the Back Up Camera view. The Back Up
Camera view can also be activated by pressing the
icon on the TrailCam view.
When the vehicle is shifted out of REVERSE with Camera
Delay turned off and TrailCam view is active, the TrailCam
mode is exited and the previous screen appears again.
When the vehicle is shifted out of REVERSE with Camera
Delay turned on and the TrailCam view is active, the
TrailCam image will be displayed for up to 10 seconds
unless the vehicle speed exceeds 8 mph (13 km/h), the
transmission is shifted into PARK, the ignition is placed in
the OFF position, or the touchscreen X button to disable
display of the TrailCam view is pressed.
Whenever the TrailCam image is activated through the
Manual Activation Methods, and the vehicle speed is
greater than or equal to 8 mph (13 km/h), a display timer
for the image is initiated. The image will continue to be
displayed until the display timer exceeds 10 seconds.
NOTE:

If the vehicle speed remains below 8 mph (13 km/h)
while in 2WD or 4WD High, the TrailCam image will
be displayed continuously until deactivated via the
touchscreen X button, the transmission is shifted into
PARK, or the ignition is placed in the OFF position.

The touchscreen X button to disable the display of the
camera image is made available ONLY when the
vehicle is not in REVERSE.

The TrailCam view will stay active regardless of the
vehicle speed and time while in 4WD Low.
Cleaning The TrailCam
Press and hold the Clean Camera button located on the
TrailCam view to wash the TrailCam. Washer fluid will stop
when the button is released.

The camera can be washed up to 20 seconds at a time
while holding the button.

The Clean Camera system is not available when
windshield washing is in process.
When enabled, active dynamic Tire Lines are projected on
the ground plane of the TrailCam view based on the
steering wheel position.
23_JT_OM_EN_USC_t.book Page 176