Jeep Gladiator 2021, Руководство пользователя

Страница: 102 / 484

100 GETTING TO KNOW YOUR VEHICLE
L
OWERING
T
HE
W
INDSHIELD
1. Before completing the steps below:

If your vehicle is equipped with a soft top,
the top MUST be lowered
Ú
page 77,
and the door frames must be removed
Ú
page 97 prior to lowering the wind -
shield.

If your vehicle is equipped with a hard
top, the Freedom Panels MUST be
removed prior to lowering the windshield
Ú
page 91.
2. Manually remove the protective caps over
the windshield wiper hex bolts.
Step Two
3. Using the provided 15 mm socket, remove
the two hex bolts and remove the wiper
arms.
4. Move to the inside of the vehicle and lower
both sun visors.
5. Using the provided #T40 Torx head driver,
remove the four Torx head fasteners
located along the interior of the windshield
(two on each side of the header trim).
Step Five
NOTE:
Store all of the mounting bolts in their original
threaded holes and tighten for safekeeping, or
in the fastener bin located below the rear seat.

Be sure that you carefully follow the instruc -
tions for raising the windshield. Make sure
that the folding windshield, windshield
wipers, side bars, and all associated hard -
ware and fasteners are correctly and tightly
assembled before driving your vehicle.
Failure to follow these instructions may
prevent your vehicle from providing you and
your passengers’ protection in some acci -
dents.

If you remove the doors, store them outside
the vehicle. In the event of an accident, a
loose door may cause personal injury.
WARNING! (Continued)
CAUTION!
Failure to follow this step will cause damage
to the vehicle’s header seal.
1 — Hex Bolt Cover Installed
2 — Hex Bolt Cover Removed
1 — Outer Torx Fasteners
2 — Center Torx Fasteners