Jeep Compass, Информационное руководство

Страница: 52 / 189

GETTING TO KNOW YOUR INSTRUMENT PANEL 51
(Continued)
Optimal conditions for completing the process
are achieved by traveling at 37 mph (60 km/h)
with engine speed above 2000 rpm.
When this light/message switches on, it does
not indicate a vehicle failure and thus it should
not be taken to a workshop.
NOTE:
On some versions, together with the symbol
switching on, the display shows a dedicated
message.
Low Diesel Emissions Additive AdBlue®
(UREA) Indicator Light — If Equipped
The Low Diesel Exhaust Emissions
Additive AdBlue® (UREA) indicator
light illuminates when the AdBlue®
level is low.
Fill the AdBlue® tank as soon as possible with
at least 1.3 gallons (5 liters) of AdBlue®.
If filling the tank is done with a remaining range
of AdBlue® in the tank equal to zero, you may
need to wait two minutes before starting the
vehicle.
Rear Fog Indicator — If Equipped
This indicator light will illuminate
when the rear fog lights are on.
Water In Fuel Indicator Light — If Equipped
The “Water In Fuel Indicator Light” will
illuminate when there is water
detected in the fuel filter. If this light
remains on, DO NOT start the vehicle
before you drain the water from the fuel filter to
prevent engine damage, and please see an
authorized dealer.
CAUTION!
Vehicle travel speed should always be
adapted to the traffic and weather conditions,
and must always comply with traffic
regulations.
The engine can be turned off if the DPF
warning light is on; however, repeated
interruptions of the regeneration process
could cause premature deterioration of the
engine oil. For this reason, it is important to
wait for the symbol to turn off before turning
off the engine. Do not complete the DPF
regeneration process when the vehicle is
stopped.
CAUTION! (Continued)
21_M6_EIG_EN_IN_t.book Page 51