Jeep Compass 2023, Руководство пользователя

Страница: 43 / 304

GETTING TO KNOW YOUR VEHICLE 41
Cornering Lights
The cornering lights are a feature to improve visibility at
night while turning the vehicle. When activated, a light
incorporated in the front fog light will illuminate on the
side of the vehicle the steering wheel is rotated or the turn
signal indicator is on. It can be activated through the
Uconnect system
Ú
page 145.
T
URN
S
IGNALS
Move the multifunction lever up or down to activate the
turn signals. The arrows on each side of the instrument
cluster display flash to show proper operation.
NOTE:
 If either light remains on and does not flash, or there
is a very fast flash rate, check for a defective outside
light bulb.

A “Turn Signal On” message will appear in the instru -
ment cluster display and a continuous chime will sound
if the vehicle is driven more than 1 mile (1.6 km) with
either turn signal on.
L
ANE
C
HANGE
A
SSIST
Lightly push the multifunction lever up or down, without
moving beyond the detent, and the turn signal will flash
five times then automatically turn off.
B
ATTERY
S
AVER
F
EATURE
To protect the battery, the interior lights will turn off
automatically 15 minutes after the ignition switch is
placed in the OFF position. This will occur if the interior
lights were switched on manually or are on because a
door is open.
INTERIOR LIGHTS
I
NTERIOR
C
OURTESY
L
IGHTS
Courtesy and dome lights are turned on when the front
doors are opened, or when the dimmer control is rotated
to its farthest upward position.
The front map/reading lights are turned on by the
switches in the center of the overhead console.
Overhead Light Switches
To protect the battery, the interior lights will turn off
automatically 15 minutes after the ignition is placed in the
OFF position. This will occur if the interior lights were
turned on manually or are on because a door is open. This
includes the glove compartment light and the cargo area
light. To restore interior light operation, either place the
ignition in the ON/RUN position, or push the light switch on
and then back off.
2
23_MP_OM_EN_USC_t.book Page 41