Jeep COMPASS 2018, Руководство пользователя

Страница: 105 / 712

possible collision with the vehicle in front using
audible/visual warnings and it applies autono-
mous braking.
Changing the FCW status to “Far” setting allows
the system to warn the driver of a possible
collision with the vehicle in front using audible/
visual warning when the latter is at a farther
distance than
" Medium " setting. This provides
the most reaction time to avoid a possible
collision.
Changing the FCW status to the “Near” setting,
allows the system to warn the driver of a pos-
sible collision with the vehicle in front when the
distance between the vehicle in the front is
much closer. This setting provides less reaction
time than the “Far” and “Medium” settings,
which allows for a more dynamic driving expe-
rience.
NOTE:
•
The system will not retain the last setting
selected by the driver after the ignition is
turned OFF. The system will reset to the
default setting when the vehicle is restarted.
•
FCW may not react to irrelevant objects such
as overhead objects, ground reflections, ob-
jects not in the path of the vehicle, stationary
objects that are far away, oncoming traffic, or
leading vehicles with the same or higher rate
of speed.
•
If FCW is disabled, unavailable screens will
be displayed.
FCW Limited Warning
If the instrument cluster display reads “FCW
Limited Functionality” or “FCW Limited Func-
tionality Clean Front Windshield” momentarily,
there may be a condition that limits FCW func-
tionality. Although the vehicle is still drivable
under normal conditions, the active braking may
not be fully available. Once the condition that
limited the system performance is no longer
present, the system will return to its full perfor-
mance state. If the problem persists, see your
authorized dealer.
Service FCW Warning
If the system turns off, and the instrument
cluster display reads:
•
FCW Unavailable Service Required
This indicates there is an internal system fault.
Although the vehicle is still drivable under nor-
mal conditions, have the system checked by an
authorized dealer.
General Information
The following regulatory statement applies to all
Radio Frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interfer-
ence.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
Tire Pressure Monitor System
(TPMS)
The Tire Pressure Monitor System (TPMS) will
warn the driver of a low tire pressure based on
the vehicle recommended cold placard pres-
sure.
The tire pressure will vary with temperature by
approximately 1 psi (7 kPa) for every 12°F
(6.5°C). This means that when the outside tem-
perature decreases, the tire pressure will de-
crease. Tire pressure should always be set
based on cold inflation tire pressure. This is
defined as the tire pressure after the vehicle has
not been driven for at least three hours, or
driven less than 1 mile (1.6 km) after a three
hour period. The cold tire inflation pressure must
not exceed the maximum inflation pressure
molded into the tire sidewall. Refer to “Tires” in
“Servicing And Maintenance” for information on
how to properly inflate the vehicle’s tires. The
tire pressure will also increase as the vehicle is
driven. This is normal and there should be no
adjustment for this increased pressure.
102