Jeep 2020 RENEGADE, Руководство пользователя

Страница: 19 / 484

GETTING TO KNOW YOUR VEHICLE 17
Remote Start Cancel Message — If Equipped
The following messages will display in the
instrument cluster if the vehicle fails to remote
start or exits remote start prematurely:

Remote Start Cancelled — Door Open

Remote Start Cancelled — Hood Open

Remote Start Cancelled — Fuel Low

Remote Start Cancelled — Liftgate Open

Remote Start Cancelled — Too Cold

Remote Start Cancelled — Time Expired

Remote Start Disabled — Start Vehicle To
Reset
The message will stay active until the ignition is
placed in the ON/RUN position.
To Enter Remote Start Mode
Push and release the Remote Start button on
the key fob twice within five seconds. The
vehicle doors will lock, the turn signals will flash
twice, and the horn will chirp. Then the engine
will start, and the vehicle will remain in the
Remote Start mode for a 15 minute cycle.
NOTE:

If an engine fault is present or fuel level is
low, the vehicle will start and then shut down
in 10 seconds.

The park lamps will turn on and remain on
during Remote Start mode.

For security, power window and power
sunroof operations are disabled when the
vehicle is in the Remote Start mode.

The engine can be started two consecutive
times (two 15 minute cycles) with the key
fob. However, the ignition must be placed in
the ON/RUN position before you can repeat
the start sequence for a third cycle.
To Exit Remote Start Mode Without Driving
The Vehicle
Push and release the remote start button one
time or allow the engine to run for the entire
15 minute cycle.
NOTE:
To avoid unintentional shut downs, the system
will disable for two seconds after receiving a
valid remote start request.
To Exit Remote Start Mode And Drive The
Vehicle
Before the end of 15 minute cycle, push and
release the unlock button on the key fob to
unlock the doors, or unlock the vehicle using
Keyless Enter-N-Go — Passive Entry via the door
handles, and disarm the vehicle security alarm
(if equipped). Then, prior to the end of the
15 minute cycle, push and release the START/
STOP ignition button.
NOTE:
For vehicles equipped with the Keyless
Enter-N-Go — Passive Entry feature, the
message “Remote Start Active — Push Start
Button” will display in the instrument cluster
display until you push the ignition START/STOP
ignition button.
2
20_BV_OM_EN_USC_t.book Page 17