WARNING
l
Do not connect to any voltage other than that shown on the rating label
of the pump.
l
Do not pump flammable liquids. The appliance is only intended to be
used in aquarium.
l
The maximum operation depth is 1.5m.
l
Do not use with water above 35
℃.
l
The supply cord cannot be replaced. If the cord is damaged the
appliance should be scrapped.
l
The pump is not intended for use by young children or infirm persons
without supervision.
l
The maximum total head is 2.8m (for 3000 and 4200 series); 2.9m (for
4000 series); 3.6m (for 5000 series)
l
To protect against the risk of electrical shock, do not immerse the plug
in water or other liquid.
l
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
l
Children should be supervised to ensure that they do not play with the
appliance.
CAUTION
Always disconnect from electrical outlet before cleaning, maintenance and
handling the pump.
Don’t operate without water.
Do not lift the pump by holding the power cord.
Do not use the pump in liquids having a temperature exceeding 35
℃
. Use
the pump only in freshwater.
Please use the pump only when it is completely submerged in water.
Must not use the pump in swimming pool.
PERFORMANCE
A clogged or dirty intake screen will greatly reduce performance.
If the pump is used on a dirty surface, raise it slightly to reduce the amount
of debris contacting the intake. If less flow is desired, adjust the regulator on
the sealing cover to restrict the flow.
Do not let the pump run when not submerged in water. That may damage
the pump. Always submerge the pump first, and then plug in the electrical
outlet. At the beginning, it probably can’t pump water, because there is air
in the pump and the tube. Don’t worry about it. Please pull out and insert
electrical outlet several times, it will work normally.
INSTALLATION DRAWIN
MAINTENANCE
Unplug before cleaning.
To clean the pump, remove the back cover, sealing cover and the impeller.
Use a small brush or stream of water to remove any debris
CAUTION: The pump shaft can not be removed.
If the pump fails to operate, check the following:
l
Check the outlet and try another outlet to ensure the pump is getting
electrical power.
NOTE: Always disconnect from electrical outlet before handling the
pump.
l
Check the pump outlet and tubing for kinks and obstructions. Algae
may block them, please flush out the algae with a garden hose.
l
Check the inlet to ensure it is not clogged with debris.
l
Remove the pump inlet to access the impeller area. Turn the rotor to
ensure it is not broken or jammed.
l
Monthly maintenance will prolong your pump’s life.
NOTE: Ensure that the electrical cord loops below the electrical outlet
to form a “Drip Loop”. This will prevent water from running down the
cord into the electrical outlet.
DISPOSAL: Do not dispose this product as unsorted
municipal waste. Collection of such waste separately for
special treatment is necessary.
