JDS Uniphase 4100, Руководство пользователя, Страница: 116 / 182

Chapter 7
Power meter and Source options of the OTDR Modules
Result page
96 User Manual 770000102/08
Commands of the
power meter
parameters
When the Powermeter function is selected, the following softkeys are
available on the results page:
The different configuration buttons are displayed:
Wavelength
selection of the wavelength
Unit
choice of the unit
Zero
Adjustment of the Zero value when the power
meter’s optical input is closed with a plug (a
validation is required).
On the results page, the following actions are available:
Set as Reference
Selects the current result as reference value to
measure the attenuation of a link. This reference
is displayed under the measurement result until a
new reference value is chosen.
Keep Result
Saves the result on the corresponding line of the
table.
Clear Table
Deletes all the results recorded in the table.
If the Source function is selected (either on this Platform, on the base
Unit or on an OTDR module, or on another Platform), the Power meter
results page is different:
– The
Wavelength
,
Unit
and
Zero
menu keys are accessible via the
menu key
Power Config.
– The
Power Ref.
menu key allows to reach the
Standard Ref
menu
key. It also allows to reach the
Jumper Ref
menu key if Power
meter function is associated with Source function onto another unit
(see
“Carrying out the reference in loopback mode” on page 100 ).
Result page of
the Source
Once the source icon is selected, the results page displays and the
Source can be configured.
Laser On / Laser Off Activation or shut-down of the laser (same
function as the
S
TART
/S
TOP
button)
Fig. 60
Source result page
MTS2100 4100 Module US rev08.book Page 96 Jeudi, 1. août 2013 1:43 13