OPERATOR’S MANUAL
FC-P30A-UL
4.
OPERATION
STORAGE
1. Disconnect supply air when not in use.
2. Always place the valve in the “OFF” position when not in
use.
3. Wrap and store the hose on the provided hose wrap brack-
et.
4. Wrap and store the ground wire on the provided wire wrap
bracket.
5. Locate the park the Gas Caddy on a flat level surface, away
from any potential ignition sources, away from any potential
hazards that may impact or damage the Gas Caddy.
6. Lock wheel brakes.
7. Be certain that the fuel gage vent dome, indicator cap, fill
tube and fill tube cap are all present and secure. Replace
any missing parts immediately.
Fig. 3
PRODUCT SPECIFICATIONS
Weight (empty):
154 lbs (69.5 kgs.)
Capacity:
30 gal (114 L)
Length:
31.25” (76 cm)
Width:
25.0” (88.9 cm)
Height:
39.50” (100.5 cm)
Approx. Flow:
7 gpm (26 L pm) @ 40 PSI
PUMPING FROM GAS CADDY TO VEHICLE
1. Position the Gas Caddy near the vehicle and lock the wheel
brakes.
2. Attach the ground wire clamp to the vehicle to a known
ground surface.
3. Place the hose inside the fill pipe of the vehicle fuel tank.
4. Align valve handle so that the point is position to the “OUT”
to vehicle position. (See Fig. 3)
5. Connect shop air supply.
WARNING: AIR SUPPLY MUST
NOT EXCEED 120 PSI.
6. Squeeze the air throttle valve to operate pump. Closely
monitor flow to prevent overfilling or spilling.
7. Release valve when desired amount is pumped.
8. Turn the valve to the “IN” to tank position.
9. Uncoil and raise the hose and briefly run the pump to return
any remaining fuel in the system to the tank.
10.Coil and hang the hose on the hanger bracket.
11.Turn valve handle to the “OFF” position.
OPERATOR’S MANUAL
FC-P30A-UL
5.
REPLACEMENT FILTERS
Fuel Type
Filter Type
Part No.
Unleaded Gasoline
10 micron
10M-FF
Diesel/Kerosene
30 micron
30M-FF
Note:Coat the O-ring seal with oil or grease before assembly. Hand tighten by
turning approximately 1/2 turn after rubber seal contacts the filter support. Do
not over-tighten.
REPLACEMENT PARTS:
Item
Description
Qty
Part No.
1
Tank
1
_____
2
Handle
1
30GC-02C
3
Cover
1
30GC-49-UL
4
Wheel (10”)
2
30GC-UL
5
Caster (5”)
2
30GC-48
6
Fuel Gage (cap/nut)
1
30GC-FGK
7
Fuel Gage (complete)
1
FC-P30-FG
8
Vent
1
30GC-08-VENT
9
Fill Tube
1
30GC-09-01
10
Fill Cap
1
30GC-09-02
11
Hose Assembly
1
80-593-NI
12
Ground Strap
1
80-572
13
Valve/Filter Support Asm.
1
30GC-30/31
14
ARO Diaphragm Pump
(UL Listed)
1
670042
15
Air Throttle Valve
1
FC-AT
16
Filter/Regulator
1
P391246000
17
Contents Decal Set
1
25GC-04
18
Hose Bracket
1
30GC-46
19
Ground Wire Bracket
1
30GC-47
20
Hose Kit (3 Hoses)
1
FC-P30A-HK
Replacement Parts & Accessories
1
2
10
6
8
13
3
9
4
11
18
15
19
12
14
16
5
17
20
Not Shown
