ASSEMBLY
7
Once the door is in place, you can begin tightening everything into place.
To start, lift the back of the door until it is parallel with the factory body
line behind it (2 door) or the top tubes on the front and back doors are
parallel (4 door). Once you are happy with that, tighten the hinge bracket
into place. If you cannot lift or drop the back enough to make the door
parallel, you may need to loosen the front hinge bracket bolts. This will
allow you to rotate the door a bit. Then, tighten them back up. Next,
make sure the latch bracket is at the correct height to allow for the latch
to catch and hold the door in place when it is closed. Tighten it into that
position. After that is in place, you will need to position and tighten the
latch. You want it to hold the door still without any rattling, while also not
having to slam the door too hard to get it to close.
8
Finally, repeat all steps to install the remaining doors.
Содержание BR6TD
Страница 4: ...INCLUDED PARTS 1L 1R 1L 1R 4x 4x 1L 1R 4 DOOR ...
Страница 5: ...INCLUDED PARTS 1L 1R 2x 2x 1L 1R 2 DOOR ...
