JCM ivizion ld, Эксплуатация и обслуживание

Страница: 67 / 158

P/N 960-100929R_Rev. 7 {EDP #148849} © 2017, JAPAN CASH MACHINE CO., LTD.
4 - 1 1
Disassembly/Reassembly iVIZION® Series Next-Generation Banknote Acceptor Unit Section 4
CIS/Transmissive Light & Upper
UV Sensor Removals
To remove the CIS, the Transmissive Light and the
Upper UV Sensors proceed as follows:
1. Push out the two (2) Alignment Pins (Figure 4-40
a
1
& a
2
) securing the two (2) Limit Stops (Figure
4-40 b
1
& b
2
) using holes provided inside the
Unit, and individually remove the two (2) Stops
from the Validation Unit.
2. Carefully spread both sides of
iVIZION
Head
FR “A” Frame apart (Figure 4-40 c
1
& c
2
), and
lift the Upper Validation Section (Figure 4-40 d )
up and out of the Validation Unit.
3. Remove the six (6) mounting Screws (Figure 4-
41 a
1
to a
6
) securing the upper
iVIZION
BG 85B
Head Assembly (Figure 4-41 b ) to the lower Vali-
dation Unit.
4. Remove the four (4) CIS Sensor Mounting
Screws (Figure 4-42 a
1
to a
4
) and remove the CIS
Sensor (Figure 4-42 b ) from the Upper Validation
Section.
5. Remove the two (2) mounting Screws (Figure 4-
42 c
1
& c
2
) securing the Transmissive Light Sen-
sor in place (Figure 4-42 d ), and remove it from
the Upper Validation Section.
NOTE: When reassembling the Unit,
ensure that the right and left side
Pins are correctly repositioned when
reinstalled.
Figure 4-40 Upper Validation Part Removal
Figure 4-40 Upper Validation Part Removal
a
1
a
2
b
1
b
2
d
c
1
c
2
Figure 4-41 iVIZION Head BG85B Removal
Figure 4-41 iVIZION Head BG85B Removal
a
1
a
2
a
3
a
4
a
5
a
6
b
NOTE: When reassembling the Unit,
ensure that the UV Sensors are
correctly re- positioned when set in
place (See “Reassembly Cautions”
on page 4-14 of this Section).
NOTE: If foreign objects are
observed adhering to the Sensor’s
surface, blow it clean by using a
Compressed Air spray.