15 - 2
Filling the Tank
!
WARNING
Lower the loader arms and switch off the engine before
refuelling. Do not permit operation of the machine
controls while refuelling.
2-3-3-9
At the end of every working day, fill the tank with the correct
type of fuel. This will prevent overnight condensation from
developing in the fuel.
The cap incorporates a side mounted barrel lock that is
operated by the ignition/door key.
Fit the Cap
Once the key has been removed, the cap will simply rotate
on the filler neck. To remove the cap from the filler neck, the
key must be reinserted and the cap unlocked.
Draining the Filter
1
Park the machine on firm level ground, engage the
parking brake and set the transmission to neutral. Raise
and block the loader arms. Lower the backhoe to the
ground and stop the engine.
2
Drain off any water in the element
A
by turning tap
B
Changing the Filter Element
1
Park the machine on firm level ground, engage the
parking brake and set the transmission to neutral.
Lower the loader arms and backhoe to the ground, stop
the engine.
2
Unscrew the filter element
A
. The element is hand tight
but may require a strap wrench to remove. The filter will
be full of fuel.
3
To assist with bleeding, fill the new filter element with
fuel before fitting. Install new element
A
hand tight only.
Check for leaks.
4
Bleed the System.
Section 3
9803/3280
Section 3
15 - 2
Issue 1
Fuel System
S233870
A
B
399470
A
B