EN
EN-15
Dual Mono / Bi Amp Mode – SDA-2200 Only
Dual mono requires the use of a SDA-2200 for each
channel.
On one of the SDA-2200’s, connect the
RED
positive
speaker terminal labelled
L+
to the positive LF terminal
of your left speaker. Similarly, connect the
BLACK
negative speaker terminal labelled
L-
to the negative LF
terminal of your left speaker.
WARNING: Speakers that support bi-amping
have a metal strip that connects the low
frequency (LF) and high frequency (HF)
terminals. This MUST be removed in a bi-
amped system
Using a second speaker cable connect the
RED
positive
speaker terminal labelled
R+
to the positive HF terminal
of your left speaker. Similarly, connect the
BLACK
negative speaker terminal labelled
R-
to the negative
HF terminal of your speaker.
Repeat this process for the right speaker, using the same
terminals on the other SDA-2200.
In this setup only one interconnect is required to
each power amplifier and it should be connected to
the
IN L
input. The interconnects can be either XLR
(recommended for longer cable runs) or phono (RCA).
Set the
INPUT
switch on both of the SDA-2200’s to the
appropriate setting for the cables used.
Note:
The
IN R
input has no function in this
arrangement.
Note:
Make sure INPUT switch
is set to input type RCA
or XLR
Make sure GAIN switch is
set to 31dB.
Make sure MODE switch
is set to dual mono
mode, DM.
Contains Transmitter module
FCC ID: APILUXASTR01
IC: 6132A-LUXASTR01
Contains Transmitter module
FCC ID: APILUXABT01
IC: 6132A-LUXABT01
SDP-55
Note: Unit should be connected via
RCA or XLR. Both versions shown for
illustrative purposes only.
SDA-2200
SDA-2200
HF
LF
HF
LF
Right
Left
