3.9
Audio shoots up when Bluetooth is on
•
Check the Bluetooth volume by holding down the SEL button until I-VOL appears. Then, press the SEL button until
BTVOL appears. This BTVOL is usually higher than the stock radio I-volume.
3.10
Moisture in Display
3.10.1
Water seen inside display after washing the mounting area
•
Radio is not designed to withstand pressurized streams of water. When rinsing the radio or around the radio, a very
low pressure spray is recommended.
3.10.2
Slight fog after operation
– normal in colder weather. Allow radio to run for 1-2 hours; this will burn off
moisture.
3.11
Bluetooth Won’t Work
3.11.1
Bluetooth Won’t Pair
Make sure your Bluetooth device is turned on and set to scan
Make sure the MBB2020 is on BT MUSIC. Hold down the MOD button until PAIRING appears
Turn all other Bluetooth devices off so the radio doesn’t get confused with what Bluetooth device to pair to.
Turn the pairing on the Bluetooth device first before pairing is turned on the radio.
Reboot your Bluetooth device.
Turn off the Wi-Fi on your Bluetooth device.
Reset your radio using the reset procedure in 5.
Try with another Bluetooth device.
Initiate warranty claim if nothing above works.
Note
: Bluetooth will only work with Bluetooth streaming in but not out. This means that phones can stream Bluetooth
music in, but Bluetooth headphones that stream out will not work.
3.11.2
Bluetooth Code needed
Bluetooth code for the JBLMBB2020 is 1234.
3.11.3
Bluetooth is Paired, but the Volume is Low
•
Make sure your volume on the Bluetooth device is on and turned up. If the volume is off on the Bluetooth device, then
audio will not play even if the radio and Bluetooth device are paired.
