JB-Lighting SPARX 10, Руководство по эксплуатации

Страница: 46 / 72

- 46 -
10
4.2 FACTORY DEFAULTS
To set back the Sparx10 to factory defaults choose in the menu FACTORY DEFAULT -> LOAD
DEFAULTS. After confirming SURE? with ENTER, the personal settings of the Sparx10 will be
set back to factory defaults.
If the white balance was adjusted before, it will be not affected by the set back to factory defaults.
4.3 USER DEFAULTS
If personal settings are done in the PERSONALITY menu, the user can save and reload it in the
USER DEFAULTS menu. To make sure that the personal settings are not changed quickly on a
stage, the save progress is locked with the password „JB-LIGHTING“.
4.4 DMX ADDRESS
Change the DMX address directly by pressing the keys „UP“ and „DOWN“. Confirm and store it
by pressing key „ENTER“. The DMX address can also be changed in the menu DMX ADDRESS.
4.5 PERSONALITY
DMX INPUT MODE
The Sparx10 provides an embedded radio-DMX receiver. The receiver works with the
JB-Lighting Wireless TRX transmitter. To enable the Sparx10 to receive radio-DMX change the
menu from WIRED (factory default) to WIRED/WIRELESS. The fixture needs to be logged in to
the Wireless TRX transmitter. To log-in press the „Start“ button (see also manual Wireless TRX).
The radio channel is displayed when the Sparx10 is logged. The main display will show the in-
tensity of the incoming signal. If the Sparx10 is connected either via DMX cable and radio-DMX,
the cable signal has priority.
DMX MODE
The Sparx10 offers 3 different operating modes (see DMX protocol page 40). Mode 1 is an 8 bit
mode with which you can control all features of your Sparx10. For using the full range of DMX
channels use the mode 2 - 16 BIT. Use this mode for smoother operation with the RGBW chan-
nels. In order to operate the Sparx10 with less DMX channels the DMX mode can be set to mode
3. In this mode there are all channels in 8 bit mode without Pan/Tilt.
PAN / TILT
RESOLUTION sets pan and tilt to 8 bit or 16 bit control resolution. The default setting is 16 bit.
If this fine resolution is not required, you can set to 8 bit for quicker operation of pan/tilt values.
The PAN INVERS and TILT INVERS commands invert the direction of pan and tilt. The PAN/TILT
SWAP command sets pan commands to tilt and vice versa.
CURVES
Dimming curves can be adjusted for the dimmer channel and the RGBW channels. There is a
square-law curve for finer control at low intensity and coarser control at high intensity and a lin-
ear-law curve available.
SHORTEST DISTANCE
This setting is only for the color wheel channel. Switched to ON (default) it always take the short-
est route from one colour to another in order to simulate a physical color wheel. Switched to OFF
it routes only from white to turquoise and backwards.
CAMERA MODE
For flicker free recording in TV-studios the Sparx10 offers three different modes from 50 Hertz
(PAL, Secam) to 60 Hertz (NTSC). Flex mode is designed, if cameras have a refresh frequen-
cy that makes the 50 or 60Hz settings ineffective. Factory default is 60Hz. Access the menu
PERSONALITY -> CAMERA MODE and choose the required frequency. To confirm press
“ENTER”. This can be also controlled with the control channel (channel 5) via lighting desk.