JB-Lighting SPARX 10, Руководство по эксплуатации

Страница: 43 / 72

- 43 -
10
The value of Sparx10 in chain depends on the local power network. Never use more than five in
one line. Power throughput cable must be rated 20A min., have three conductors 1,5mm² min.
conductor size and a outer cable diameter of 5-15mm. Use only original PowerCon plug from
Neutrik. See installation manual from manufacturer (www.neutrik.com).
The Sparx10 is equipped with a backlit graphic display, which can be rotated through 180 deg.
if the unit is installed upside down.
Rotating the display
Use the centred button to change the orientation of the display. To adjust the personal setting of
the Sparx10 use keys located on the control panel. Functions see menu on the following page.
The Sparx10 can be addressed in the main menu. For addressing in a case, the reset can be
aborted by pressing the right base button during powering the fixture. The main menu also in-
forms about the DMX-mode. If wireless DMX is used, the field intensity from the sender will be
displayed. Press „ENTER“ to enter a menu, select a function or apply a selection. Press keys
„DOWN“ and „UP“ to scroll within a menu or set values. To escape a function press key „ESC“.
A few functions can be entered or recalled by means of a combination of two keys. For example
FINE ADJUST at menu SERVICE and MODIFY, RUN and REMOTE at menu STANDALONE. To
enter these functions press „ENTER”, keep it down and press “ESC” in addition. To leave the
menu press „ESC“ hold it down and press „Enter“, MODIFY and FINE ADJUST you can leave
only by pressing „ESC“.
The main menu can be locked to avoid an accidental change of the configuration. To lock press
“ENTER” and keep it down and press “ESC” in addition. To unlock press „ESC“ (keep it down)
and press „ENTER“ in addition.
Special functions are assigned to the display lighting:
The display is not illuminated during reset. Slow flashing of the display illumination means no
DMX signal is connected. Fast flashing of the display illumination showing „JB-Lighting“ means
a failure was reported and stored in the ERROR LIST (To clear - see menu navigation on next
page). Fast flashing of the display illumination showing an error message means an current fail-
ure is reported, e. g. *PAN TIMEOUT - please contact your dealer or our service department. If
the Sparx10 receives a DMX-signal the display illumination dims out after 30 seconds in order
not to irritated during standard operation.
Color Function Symbol
brown Live „L“
blue Neutral „N“
green/yellow Ground
4. Control panel