JB-Lighting P9 Beamspot, Руководство по эксплуатации

Страница: 10 / 44

- 10 -
P9
5. Installation
5.1 Unpacking the device
Contents of the packaging: This spotlight, two Omega brackets with original Camloc fasteners,
powerCON-TRUE1 cable and a safety note. These instructions are included in the shipment.
Open the packaging at the top and remove the powerCON TRUE1 cable, the inlay and the safety
instructions. The Omega brackets are located under the spotlight. Check the P9 Beamspot for
possible transport damage. This should be communicated immediately to the transport company.
The maximum ambient temperature of 45°C must not be exceeded.
Do not operate the device until you have become familiar with its functions. Prevent operation by
persons who are not qualified to use the device. Most damage is the result of improper operation!
Please use the original packaging or specially adapted flight cases if the device is to be transported.
When using the original packaging, the locks must not be closed!
ATTENTION: Only have plugs installed by a specialist!
!
The P9 Beamspot is supplied with an assembled Schuko power cable with the powerCON-
TRUE1 plug (only the powerCON-TRUE1 plug is included in the US version). The installation of
the power connection of the P9 Beamspot to the power supply (100-240 Volt, 50 - 60 Hertz)
must be carried out by an authorised specialist.
Connection in Germany/Europe:
Wire colour
Function
Symbol
Brown
Phase
“L”
Blue Neutral wire “N”
Green/Yellow Protective earth “PE”
5.2 Fitting the plug to the connection cable
ATTENTION: The distance between the light emission and the surface to be
illuminated must be at least 2.0 metres.
ATTENTION: The front lens must be replaced if it is visibly damaged to the extent
that its function is impaired, e.g. by cracks or deep scratches!
ATTENTION: To avoid damaging the internal parts of the light head, never let sunlight
shine directly into the front lens.
!
!
!