- 3 -
Basic function introduction
1. PTC Fuse inside the transformer, to prevent overload.
2.
“
Operate
”
button on the display board.
3. Copper worm gear inside the motor. With high impact resistant strength.
4. Multiple highlight LED lighting.
5. Multifunction external terminal can be used to connect various external devices such as photo beams, push button
switches, WIFI smart controllers & flashing lights.
6. LED display for ease of use and adjustment.
7. Rolling code transmitters, with billions of possible codes for security.
8. Soft start, soft stop operation minimizes start-up load on garage door opener and garage door and ensures low noise,
smooth operation.
9. Micro intelligent mapping. During operation, the opener utilizes real-time detection of resistance to ensure precise
positioning and force monitoring.
10. Adjustable time auto close function.
11. Self-locking function so the garage door can still be locked manually in the event of a power outage.
12. 1200Nm lifting force.
13. Safety reverse function. The door will reverse to the fully open position when encountering a solid obstacle on
closing cycle and stop when encountering excess resistance on the open cycle. These values are adjustable from the
menu.
14. Backup battery interface available in case of power failure or low voltage.
15. Original opening & closing force self-learning.
16. Low-voltage protection & cut out.
17. Strong metal chassis.
18. Re-enforced belt drive
Installation recommendations
Legal requirements and standards must be adhered to, please take notice of the following points to ensure maximum
safety and reliability of your new garage door opener.
Before installation, check the surrounding environment. Carefully evaluate any hazards which may be present.
Remember -
this unit has main voltage running through it (electrocution hazard, fire hazard).
Take care with the control unit; the parts may be subject to damage if the control unit is abused.
