Jaypro Retractable Practice Cages - Installation and Operating Instructions
www.jaypro.com / (800) 243-0533 / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
COPYRIGHT 2017 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
BBC-700 REV B, RELEASED 12-29-2017
Sheet 15 of 26
MOTOR
REFERENCE
POINT
70' CAGE LENGTH
Figure 14: Rendering of Second DPC-A Installation
WALL TO CAGE EDGE
i.
Drill thru the swaged end of the first drive pipe segment by using the pre-drilled holes
on the non swaged end of the second drive pipe as alignment.
ii.
Insert a 3/8 x 3 Bolt (HS292) thru the hole and secure the pipes together with a
3/8-16 nylon lock nut (HN265)
INSTALL THE SECOND DRIVE PIPE CARRIER ASSEMBLY:
1.
You will continue to work away from the motor reference point.
2.
The strut for the second drive pipe carrier is installed with strut beam clamps at a location that is
11 from the first drive pipe carrier location.
3.
Loosely install a DPC-A to that strut and adjust for Drive Pipe Center line AFF.
4.
Secure all nuts to mount the assembly to the strut.
INSTALL THE SECOND DRIVE PIPE SEGMENT TO THE FIRST DRIVE PIPE SEGMENT:
1.
Insert a drive pipe segment through the second DPC-A towards the first drive pipe segment.
2.
Insert the drive pipe segment non-swaged end first through the second DPC-A.
3.
Allow the non swaged end of Drive pipe segment 2 to go over the swaged end of drive pipe
segment one.
4.
Insert the second drive pipe fully over the swage of drive pipe segment one.
5.
Splice the drive pipe segments together (refer to Figure 9).
FIRST DPC ASSEMBLY
CABLE GUIDE PAIRS
11'-0"
SECOND DPC ASSEMBLY
