Jayco TERRAIN 2023, Руководство пользователя

Страница: 56 / 91

Section 8: Plumbing System
51
2. Open the “fresh tank drain” valve.
3. Open the low point drain valves. There is a label to indicate where the drains are lo-
cated.
4.
Turn ON the water pump and allow it to run until water no longer flows.
Some water may remain in the lines. If the recreation vehicle will be exposed to cold tem-
peratures, it must be winterized to protect the plumbing system and components. Damage
to the water lines and components due to freezing is not covered by warranty. Refer to the
Sanitizing/Winterizing the Plumbing System for details
Utility Center (P4)
The Utility Center
allows you to perform the fol-
lowing functions:
Power fill the fresh water tank for remote or dry
camping
Use the pump to supply water to fixtures from the
fresh water tank
Use the pump to siphon fill or sanitize the fresh wa
-
ter tank from a bucket
Connect to city water at the camp site to supply wa-
ter to RV fixtures
Winterize the plumbing lines and fixtures
Rinse off items outside the unit with a hot/cold fau
-
cet
City Water Connection Inlet
Use a non-toxic drinking water hose dedicated only to supplying fresh water. To prevent
contamination, keep the non-toxic drinking water hose from coming into contact with the
ground. Install the city water connection inlet cap when the fresh water connection is not
being used. The fresh water connection should be disconnected (i.e., the non-toxic drinking
hose disconnected) when the recreation vehicle is unattended for any amount of time.
City Water (Pressurized fresh water source)
The City Water connection allows you to power fill you fresh water tank. It can also be used
as a fresh water supply using your non-toxic drinking hose.
™
NOTE: If the utility center is used for a continual water source, the back
door of the motor home will need to remain open.
1. Connect the fresh water hose to the CITY WATER inlet.
2. Set the color-coded valves to the CITY WATER setting (refer to the Utility Center label
for valve configuration).
3. Connect other end of the hose to the pressurized fresh water source.
Turn ON the pressurized water source.
A check valve is located inside the city water connection inlet on the utility
center.
NEVER
depress the check valve on the “CITY WATER CON-
NECTION” inlet with pressure in the line
. It will cause
irreparable
dam-
age to the valve function and the inlet will leak water.
Table of Contents