Jayco Precept, Руководство пользователя

Страница: 95 / 165

93
Section 6: Electrical System
5. For better performance and engine life, especially in colder weather, let the generator
engine warm up for two minutes before turning “ON” 120-volt appliances.
6. The small display (hour meter) is used to keep track of run time on the generator.
The TEST switch will initiate an automatic generator start/stop sequence. This test attempts
to turn on the generator and allow it to run for at least 30 seconds before shutting it off, and
is used to confirm that the AGS is configured correctly for your generator type.
The RESET switch will disable the AGS system. The ENABLE and STATUS indicators
will go off and the generator (if running will shut off).
Disengaging the parking brake and turning on the ignition will disable the AGS system if it
was previously enabled. To reset it again, the parking brake must be set, and the ignition
turned off. The ENABLE switch on the command center panel must be selected again to put
the system in automatic start mode.
Solar Prep (if so equipped)
Your motorhome may be equipped with a roof mount solar panel quick connection. This
allows a (customer purchased) solar panel to be installed permanently on the roof. Installa-
tion will consist of the solar panel(s), regulator and wiring/fusing between the regulator and
batteries. There are no other solar plugs for portable solar panels on the vehicle.
The (black ABS) solar prep box is located in a basement compartment of the RV and is
marked with a solar prep label (indicating wire colors and polarity). There is also an ad-
ditional label indicating the RV is wired for solar.
When connected, the solar panel will supply power to the battery, the battery will supply
power to the converter, and the converter will supply power to all the 12V systems as needed.
Table of Contents Maintenance Record