Jayco Precept, Руководство пользователя

Страница: 147 / 165

145
Section 12: Interior
Vinyl Flooring
Periodically vacuum or sweep to remove dirt and gritty particles. Although most common
spills will not permanently stain the vinyl floors, they are usually easier to remove if wiped
up before they set. Blot with a paper towel and wipe clean with a damp cloth. Do not use
dish detergents or vinegar and water because they will dull your floor.
To care for the vinyl floor covering, use a damp mop with water and a mild cleaner on the
entire floor. DO NOT SOAK THE FLOORING. Use care to avoid wetting the carpet edges.
To avoid problems of “yellowing” linoleum, the flooring manufacturer recommends avoid -
ing cleaners that contain oil based solvents (i.e. lemon oil, Murphy’s Oil Soap, etc.).
Ceiling Fabric
The ceiling fabric is made from padded vinyl fabric. Wash with mild detergent and water.
Use a soft bristle brush for stubborn soil. Rinse and dry. Some household cleaners and sol-
vents remove plasticizers from vinyl, making them brittle. Abrasive cleaners may mar or
scratch the surface. Always test a small hidden area before applying cleaners to the vinyl
surface.
Privacy Drape Installation
1. Starting on the driver’s side, attach the black plastic hook to the loop on the wall (be-
hind the driver’s seat). Make sure the Velcro® on the drape is facing the motorhome
windshield.
2. Pull the drape towards the windshield and past the driver’s side sun visor. Open the sun
visor against the windshield to hold the drape in place.
3. Continue across the windshield to the passenger side, again opening the sun visor and
placing the drape behind it.
4. Attach the black plastic hook on the passenger side of the drape, to the loop on the wall
behind the passenger’s seat.
5. Attach the Velcro® at the top edge of the drape to the corresponding Velcro® on the cab
area roof (above the driver’s and passenger’s doors).
6. Attach the Velcro® at the bottom corners of the drape to the corresponding Velcro®
on the wall.
Bed Storage
Additional storage has been provided under the bed. To access the storage area, grasp the
end ledge at the foot of the bed and lift carefully. The bed platform must be held when
raised
.
It is recommended that two people retrieve stored items from under the bed so that one
person may hold the platform, and the other to retrieve the stored items from under the bed.
Lower the platform slowly to close it. DO NOT DROP THE PLATFORM.
Certain models may be equipped with a
prop rod or gas struts
to assist with easy access to
under bed storage.
Prop Rod (if so equipped)
If your model is equipped with a prop rod:
 With the help of a second person, raise the bed platform.
 Release the prop rod from its holder.
 Put the end of the rod in the bracket under the bed platform.
 To lower the platform, release the prop rod from the bracket under the bed plat-
form, re-attach the prop rod to the holder on the bed base,
 Lower the platform slowly until closed.
Table of Contents Maintenance Record