Jayco PINNACLE FIFTH WHEELS 2019, Руководство пользователя

Страница: 96 / 185

94
Section 6: Electrical System
120-Volt Circuit Breakers
The 120-volt AC circuit breakers located inside the load center protect all 120-volt wiring
and components from circuit overloads and short circuits. Should a circuit overload or short
circuit occur the circuit breaker protecting the affected circuit will “trip” preventing the flow
of electricity through that circuit.
If a circuit breaker trips, shut “off” the appliance on that circuit (i.e., power converter etc.)
and allow the circuit breaker to cool down for a brief period of time. After it cools down,
reset the circuit breaker by moving its lever “off” and then back to the “on” position. If the
circuit breaker re-trips or frequently trips, contact your dealer to have the electrical problem
diagnosed and repaired.
A circuit breaker identification label is permanently attached to the inside surface of the
120-volt Load Center.
Rotating Dial Disconnect Switch
When this switch is ON, there will be a green area showing a
“1” along the top of the switch. To turn the switch OFF, turn it
counter-clockwise until you see the red area along the left side
of the switch showing a “0” (zero).
Lever Type Disconnect Switch
To operate this switch, turn the lever counter-clockwise to turn
off all 12VDC power to the fuse panel in the RV. The lever
can be removed and is equipped with a lanyard to keep the key
from getting lost.
Battery Disconnect Switches
Switch appearance
may vary by model
Load Center
The Load Center contains 12VDC fuses and 120VAC circuit breakers for almost all of the
electrical appliances and circuits in the RV. The 120V main breaker may be located in this
panel and will turn off all 120-volt power to the RV. Locations will vary by model. Refer
to the diagram inside the load center for specific fuse assignments. Not all load centers will
include a main breaker.
Motor homes may have sepa-
rate small panels for breakers
and fuses. They are normally
located in close proximity to
each other typically in the
bed platform. The converter
is also mounted separately
(typically under the bed plat-
form).
Typical Load Center Panel
Load Center Panel w/120 volt
Main Breaker
load center appearance and con-
figuration may vary by model
Maintenance Record Table of Contents